So for the seedling tent I have it configured with the following:
- Took two large home depot boxes and joined them together using tape
- Wrapped all of inside with mylar wallpaper to add reflective material
- Carved out 3 boxes to insert PC fans for air flow
- Installed the Monios-L LED lights (two 4ft lamps) across the top of the enclosure. Placed about 18" above soil pots
- Placed tarp in front of open space on boxes to help maintain humidity. Small aquarium humidifier being used when needed to keep humidity over 70%

The goal here is to germinate the seeds in rapid rooters. Once a root is shown on the bottom of the RR tray, the seeds (along with the RR they are contained in) will be transplanted into the soil pots

I also cut three 1L soda bottles to help further retain humidity for the sprouts once they pop up from the soil. Would like to ideally have it close to 75-80% for the first couple weeks, then gradually decrease humidity through veg period

Additional notes outlined below:

>> Setup grow tent for germination / seedling growth. Temp reading at 84 F and PPFD at 18 inches above soil surface is around 250-260 range
>> Water used tested at 7.0 pH. Treated with pH Up until desired pH was met at 7.7 pH (Target is 6.2 pH)
>> Took three rapid rooters and dunked in bowl containing water w/H₂O₂ (Also after adjusting pH to 7.7)
>> Soaked thoroughly until air bubbles no longer appeared, then gently squeezed and placed in rooter grow tray
>> Added seeds into rapid rooters for germination
>> Placed hydrometer into tray for monitoring
>> Sprayed water on top of enclosure and placed soil tray in tent
>> Leaving lights on for 24 hours until sprouts emerge from rooter soil